iPhone 7/7 Plus/8/8 Plus Replacement Home Button

iPhone 7/7 Plus/8/8 Plus Replacement Home Button

Replace a home button assembly in your iPhone 7/7 Plus/8/8 Plus and fix an unresponsive home button.

iPhone 8/8 Plus Wireless Charging Antenna Connector

Replace corroded, bent, or missing contact wires with a new wireless charging antenna cable connector for your iPhone 8 or 8 Plus and save a logic board from e-waste.

Note: This component is one of 6 cable connectors surface soldered to the lower end of the logic board.

iPhone 8 Front Camera and Sensor Connector Bracket

Replace a bent or missing metal bracket that secures the connector for the front-facing camera and front panel sensor cable as well as the rear-facing camera connector to the logic board.

iPhone 8/8 Plus/SE 2020 Proximity Sensor Frame

This tiny clear plastic frame is adhered to the back of the front glass panel near the top edge and holds the proximity sensor in place.

iPhone 8 Case Button Set

• This set of exterior case buttons includes the Power/Lock Button, Volume Buttons, and the Vibrate/Ring Switch for replacing buttons with cosmetic troubles.
• These are the button parts visible on the outside of the case.
• The actual buttons and switch that do all the work are attached to the internal button cables.

iPhone 8 Battery

• 100% factory tested with a customer return rate of only 1%.
• Tested to confirm there are no cycles on the cell and the capacity is 95% or higher.
• Spot tested by iFixit staff in San Luis Obispo, CA to ensure consistency of quality and capacity.
• Assembled using high quality chipset from Texas Instruments.
• Battery adhesive is preinstalled to improve the quality of your repair.

Battery degradation is an inevitable part of your iPhone's lifespan, extend it with this new replacement battery compatible with 8. If your iPhone 8 won't turn on, is stuck in a boot loop, has a "service battery" warning, or simply won't hold a charge, this replacement battery may be what you need to fix it.

Note: For optimal performance, calibrate your newly installed battery: Charge it to 100% and keep charging it for at least 2 more hours. Then use your device until it shuts off due to low battery. Finally, charge it uninterrupted to 100%.